Canon imagePROGRAF iPF9400 Setup Guide - Page 7
Remove the Packaging Material
View all Canon imagePROGRAF iPF9400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Remove the Packaging Material 1 Remove the tape and other packaging material used to secure the printer. 2 Open the Top Cover. 3 Use the Allen Wrench to loosen the Belt Stopper screw (a) and remove the screw from the Belt Stopper. Unscrew the Belt Stopper to the left and remove the stopper. Pull the carriage spacer (b) in the direction of the arrow to remove it. a b • The Belt Stopper, screw, carriage spacer, MEMO and Allen Wrench are needed when moving the printer to another location later. Keep the Belt Stopper, screw, carriage spacer, and Allen Wrench which have been removed. Neglecting to attach the Belt Stopper and carriage spacer may cause damage to the printer when moving the printer to another location. • After opening the Top Cover, Cleaning Brush is stored on the right. Take out the brush when cleaning inside the Top Cover. 4 Lift the Ejection Guide. 5 Attach the six Ejection Supports (a) on the back of the Ejection Guide. 6 Close the Ejection Guide and Top Cover. a 7 When lowering the Ejection Guide (a), lower it slowly. If you lower it vigorously, the Ejection Supports (b) may touch the roll paper and scratch the printing surface. 8 Plug the power cord into the Power Supply Connector on the back of the printer. 9 Plug the power cord into the outlet. a b 7