Celestron CGEM II 800 Schmidt-Cassegrain Telescopes CGEM II EQ Mount Manual 5l - Page 11
Adjusting the Mount in Azimuth, Powering the Telescope
View all Celestron CGEM II 800 Schmidt-Cassegrain Telescopes manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
It is best to always make final adjustments in altitude by moving the mount against gravity (i.e., using the rear latitude adjustment screw to raise the mount). To do this you should loosen both latitude adjustment screws and manually push the front of the mount down as far as it will go. Tighten the rear adjustment screw to raise the mount to the desired latitude. Adjusting the Mount in Azimuth For rough adjustments in azimuth, simply pick up the telescope and tripod and move it. For fine adjustments in azimuth: Turn the azimuth adjustment knobs located on either side of the azimuth housing. While standing behind the telescope, the knobs are on the front of the mount. • Turning the right adjustment knob clockwise moves the mount toward the right. • Turning the left adjustment knob clockwise moves the mount to the left. Both screws push off of the alignment peg on the tripod head, which means you may have to loosen one screw while tightening the other. The screw that holds the equatorial mount to the tripod may have to be loosened slightly. Keep in mind that adjusting the mount is done during the polar alignment process only. Once polar aligned, the mount must NOT be moved. Pointing the telescope is done by moving the mount in right ascension and declination, as described earlier in this manual. Powering the Telescope The CGEM II mount can be powered by the supplied car battery adapter or or the optional AC to DC adapters supplied by Celestron. Use only adapters supplied by Celestron. Using any other adapter may damage the electronics and will void your manufacturer's warranty. 1. T o power the telescope with the car battery adapter (or 12V AC adapter), simply plug the round post into the 12V outlet on the electronic panel and plug the other end into your car's cigarette lighter outlet or portable power supply. 2. Turn on the power to the telescope by flipping the switch, located on the electronics panel, to the "On" position. ENGLISH | 11