Chamberlain B2212T Installation Manual - English - Page 10
STEP 3 Install the Idler Pulley, HARDWARE
View all Chamberlain B2212T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Assembly STEP 2 Fasten the Rail to the Motor Unit To avoid SERIOUS damage to garage door opener, use ONLY those bolts/fasteners mounted in the top of the opener. 1. Insert a 1/4"-20 x 1-3/4" bolt into the cover protection bolt hole on the back end of the rail as shown. Tighten securely with a 1/4"-20 lock nut. DO NOT overtighten. 2. Remove the bolts from the top of the motor unit. 3. Use the carton to support the front end of the rail. 4. Place the "U" bracket, flat side down onto the motor unit and align the bracket holes with the bolt holes. 5. Fasten the "U" bracket with the previously removed bolts; DO NOT use any power tools. The use of power tools may permanently damage the garage door opener. HARDWARE Bolt 1/4"-20x1-3/4" Lock Nut 1/4"-20 Bolt "U" Bracket Bolts (Mounted in the garage door opener) Cover Protection Bolt Hole Lock Nut 10