Cisco 7911G Administration Guide - Page 82
Using External Devices with Your CiscoUnifiedIPPhone, with the EMC Directive [89/336/EC].
UPC - 882658036361
View all Cisco 7911G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Chapter 3 Setting Up the Cisco Unified IP Phone Understanding the Cisco Unified IP Phones 7906G and 7911G Components Using External Devices with Your Cisco Unified IP Phone The following information applies when you use external devices with the Cisco Unified IP Phone: Cisco recommends the use of good quality external devices (headsets) that are shielded (screened) against unwanted radio frequency (RF) and audio frequency (AF) signals. Depending on the quality of these devices and their proximity to other devices such as mobile phones or two-way radios, some audio noise may still occur. In these cases, Cisco recommends that you take one or more of the following actions: • Move the external device away from the source of the RF or AF signals. • Route the external device cables away from the source of the RF or AF signals. • Use shielded cables for the external device, or use cables with a better shield and connector. • Shorten the length of the external device cable. • Apply ferrites or other such devices on the cables for the external device. Cisco cannot guarantee the performance of the system because Cisco has no control over the quality of external devices, cables, and connectors. The system will perform adequately when suitable devices are attached using good quality cables and connectors. Caution In European Union countries, use only external headsets that are fully compliant with the EMC Directive [89/336/EC]. Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0 3-8 OL11954-01