Cisco 7971G-GE Administration Guide - Page 62
Verifying the Phone Startup Process
![]() |
UPC - 746320966588
View all Cisco 7971G-GE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Verifying the Phone Startup Process Chapter 3 Setting Up the Cisco Unified IP Phone Procedure Step 1 Step 2 Step 3 Step 4 Push in the footstand adjustment button. Adjust the footstand so it is flat against the back of the phone. Insert two screws into a wall stud, matching them to the two screw holes on the back of the footstand. The keyholes fit standard phone jack mounts. Hang the phone on the wall. Figure 3-4 Parts Used in Wall Mounting the Cisco Unified IP Phone 1 Footstand adjustment button-Raises and lowers adjustment plate 2 Wall mounting screw holes 3 Adjustment plate-Raises and lowers phone vertically Verifying the Phone Startup Process After the Cisco Unified IP Phone has power connected to it, the phone begins its startup process by cycling through these steps. 1. These buttons flash on and off in sequence: - Headset. (Only if the handset is off-hook when the phone powers up. In this case, hang up the handset within 3 seconds or the phone launches its secondary load instead of its primary load.) - Mute. - Speaker. 2. Some or all of the line keys flash orange. 3-10 Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 7.0 OL-15299-01
![](/manual_guide/products/cisco-7971gge-administration-guide-f7f97bc/62.png)