Cisco C7200-I User Guide - Page 15
Examples, Related Commands, Command, Description, show interfaces gigabitethernet, show controllers - - i o ge e
UPC - 746320365398
View all Cisco C7200-I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Cisco 7200-I/O-GE+E and Cisco 7200-I/O-2FE/E Input/Output Controllers show interfaces gigabitethernet Examples The following example displays sample output of the show interfaces gigabitethernet command: Router# show interfaces gigabitethernet 0/0 GigabitEthernet0/0 is up, line protocol is up Hardware is 82543 (Livengood), address is 00d0.ffb6.4c00 (bia 00d0.ffb6.4c00) Internet address is 11.1.1.3/8 MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Full-duplex mode, link type is autonegotiation, media type is SX output flow-control is on, input flow-control is on ARP type:ARPA, ARP Timeout 04:00:00 Last input 00:00:04, output 00:00:03, output hang never Last clearing of "show interface" counters never Queueing strategy:fifo Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 2252 packets input, 135120 bytes, 0 no buffer Received 2252 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 watchdog, 0 multicast, 0 pause input 0 input packets with dribble condition detected 2631 packets output, 268395 bytes, 0 underruns 0 output errors, 0 collisions, 2 interface resets 0 babbles, 0 late collision, 0 deferred 0 lost carrier, 0 no carrier, 0 pause output 0 output buffer failures, 0 output buffers swapped out Related Commands Command show controllers gigabitethernet Description This command displays initialization block information, transmit ring, receive ring, and errors for the interface controllers about a Gigabit Ethernet interface. 12.1(5)T and 12.2(14) S 15