Cisco C7200-I User Guide - Page 3

Cisco 7200-I/O-GE+E and Cisco 7200-I/O-2FE/E Input/Output Controllers Supported Standards, MIBs, and RFCs Supported Standards, MIBs, and RFCs Standards No new or modified standards are supported by this feature. MIBs No new or modified MIBs are supported by this feature. For descriptions of supported MIBs and how to use MIBs, see the Cisco MIB web site on CCO at http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml. RFCs No new or modified RFCs are supported by this feature. Configuration Tasks See the following sections for configuration tasks for the Cisco 7200-I/O-GE+E and the Cisco 7200-I/O-2FE/E feature. Each task in the list indicates if the task is optional or required. • Configuring the Interface Transmission Mode (Optional) • Configuring Interface Speed (Optional) • Configuring the Ethernet, Fast Ethernet, and Gigabit Ethernet Interfaces (Required) • Verifying the Configuration (Optional) Note For Cisco 7200 VXR routers used as router shelves in AS5800 Universal Access Servers, use the router-shelf/slot/port command format for all interface commands. Configuring the Interface Transmission Mode This section describes the procedure for configuring the interface transmission mode. The Fast Ethernet and Ethernet interfaces on the Cisco 7200-I/O-2FE/E are duplex auto by default. Step 1 Step 2 Step 3 Command Purpose Router(config)# configure terminal Router(config-if)# interface fastethernet 0/01 Enters configuration mode and specifies that the console terminal is the source of the configuration subcommands. Selects the Fast Ethernet interface to configure. Router(config-if)# duplex full Changes the Fast Ethernet interface port transmission mode to full duplex from autonegotiation. 1. Use the interface fastethernet router-shelf/slot/port command for a Cisco 7200 VXR used as a router shelf in an AS5800 Universal Access Server. 12.1(5)T and 12.2(14) S 3