Cisco CISCO876-SEC-I-K9 Configuration Guide - Page 100

Configure Bridging on VLANs Chapter 9 Configuring a Wireless LAN Connection Step 10 Command power [client | local] [cck [number | maximum] | ofdm [number | maximum]] Example: Router(config-if)# power local cck 50 Router(config-if)# power local ofdm 30 Router(config-if)# Purpose (Optional) Specifies the radio transmitter power level. See the Cisco Access Router Wireless Configuration Guide for available power level values. Step 11 channel [number | least-congested] Example: Router(config-if)# channel 2462 Router(config-if)# Step 12 station-role [repeater | root] Example: Router(config-if)# station-role root Router(config-if)# (Optional) Specifies the channel on which communication occurs. See the Cisco Access Router Wireless Configuration Guide for available channel numbers. (Optional) Specifies the role of this radio interface. You must specify at least one root interface. Step 13 exit Example: Router(config-if)# exit Router(config)# Exits interface configuration mode, and enters global configuration mode. Configure Bridging on VLANs Perform these steps to configure integrated routing and bridging on VLANs, beginning in global configuration mode: Step 1 Command or Action bridge [number | crb | irb |mac-address-table] Example: Router(config)# bridge irb Router(config)# Step 2 interface name number Example: Router(config)# interface vlan 1 Router(config)# Purpose Specifies the type of bridging. The example specifies integrated routing and bridging. Enters interface configuration mode. We want to set up bridging on the VLANs, so the example enters the VLAN interface configuration mode. Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide 9-4 OL-5332-01