Cisco CISCO876-SEC-I-K9 Configuration Guide - Page 29
Configuring RIP
UPC - 882658021800
View all Cisco CISCO876-SEC-I-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Chapter 1 Basic Router Configuration Configuring Dynamic Routes Configuring RIP Perform these steps to configure the RIP routing protocol on the router, beginning in global configuration mode: Step 1 Command router rip Example: Router> configure terminal Router(config)# router rip Router(config-router)# Task Enters router configuration mode, and enables RIP on the router. Step 2 version {1 | 2} Specifies use of RIP version 1 or 2. Example: Router(config-router)# version 2 Router(config-router)# Step 3 network ip-address Example: Router(config-router)# network 192.168.1.1 Router(config-router)# network 10.10.7.1 Router(config-router)# Specifies a list of networks on which RIP is to be applied, using the address of the network of directly connected networks. Step 4 no auto-summary Example: Router(config-router)# no auto-summary Router(config-router)# Disables automatic summarization of subnet routes into network-level routes. This allows subprefix routing information to pass across classful network boundaries. Step 5 end Example: Router(config-router)# end Router# Exits router configuration mode, and enters privileged EXEC mode. For complete information on the dynamic routing commands, see the Cisco IOS Release 12.3 documentation set. For more general information on RIP, see Appendix B, "Concepts." OL-5332-01 Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide 1-13