Cisco CISCO876-SEC-I-K9 Configuration Guide - Page 31
Configuration Example, Verifying Your Configuration
UPC - 882658021800
View all Cisco CISCO876-SEC-I-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Chapter 1 Basic Router Configuration Configuring Enhanced IGRP Step 2 Command network ip-address Example: Router(config)# network 192.145.1.0 Router(config)# network 10.10.12.115 Router(config)# Step 3 end Example: Router(config-router)# end Router# Purpose Specifies a list of networks on which EIGRP is to be applied, using the IP address of the network of directly connected networks. Exits router configuration mode, and enters privileged EXEC mode. For complete information on the IP EIGRP commands, see the Cisco IOS Release 12.3 documentation set. For more general information on EIGRP concepts, see Appendix B, "Concepts." Configuration Example The following configuration example shows the EIGRP routing protocol enabled in IP networks 192.145.1.0 and 10.10.12.115. The EIGRP autonomous system number is 109. Execute the show running-config command from privileged EXEC mode to see this configuration. ! router eigrp 109 network 192.145.1.0 network 10.10.12.115 ! Verifying Your Configuration To verify that you have properly configured IP EIGRP, enter the show ip route command, and look for EIGRP routes indicated by "D." You should see verification output similar to the following example. Router# show ip route Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2 i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2 ia - IS-IS inter area, * - candidate default, U - per-user static route o - ODR, P - periodic downloaded static route Gateway of last resort is not set 10.0.0.0/24 is subnetted, 1 subnets C 10.108.1.0 is directly connected, Loopback0 D 3.0.0.0/8 [90/409600] via 2.2.2.1, 00:00:02, Ethernet0/0 OL-5332-01 Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide 1-15