Cisco SGE2000P Administration Guide - Page 10
Reset Switch, LAN Ports - 24 port gigabit switch
UPC - 745883572137
View all Cisco SGE2000P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Chapter Reset Switch The Ethernet switch can be reset by inserting a pin or paper clip into the RESET opening. If the reset switch is held for 10 seconds or longer, the Ethernet switch will be reset to its default settings. CAUTION: All user-defined settings are lost when you hold the Reset button for 10 seconds or longer; the Ethernet switch reverts to its default settings. When a unit is reset to its default setting, the unit restarts in stackable mode using default stacking ports with autonumbering enabled. Pressing the reset button on the master unit of a stack resets all units in the stack. LAN Ports The Ethernet switch is equipped with 24 Ethernet ports. 1-24 The Switch is equipped with 24 auto-sensing, Ethernet (IEEE 802.3) network ports, which use RJ-45 connectors. The Gigabit Ethernet ports support network speeds of 10Mbps, 100Mbps, and 1000Mbps. They can operate in half and full-duplex modes. Auto-sensing technology enables each port to automatically detect the speed of the device connected to it, and adjust its speed and duplex accordingly. In stacking mode, two ports are used for stacking. By default, the stacking ports are 12 and 24. Ports 11, 12, 23, and 24 are shared with GBIC1, GBIC3, GBIC2, GBIC4 respectively. If shared port pairs are both connected, then the mini-GBIC port takes priority. Linksys One Ready Communications Solution 2 5 Chapter 2: Getting to Know the Switch The Front Panel