Cisco SGE2000P Administration Guide - Page 48
The IP Configuration screen displays these choices: the IP Address Settings, HTTP, IP Configuration - layer 3
UPC - 745883572137
View all Cisco SGE2000P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Chapter IP Configuration The IP Configuration screen displays these choices: the IP Address Settings, HTTP, HTTPS Configuration, and Network Configuration of the Ethernet switch. IP Address Configuration (Layer 2) The IP information of the Ethernet switch is displayed here. IP Address Subnet Mask Default Gateway Management VLAN DHCP client The IP Address of the Ethernet switch is displayed. Verify that the address you enter is correct and does not conflict with another device on the network. The subnet mask of the Ethernet switch is displayed. The IP address of your network's default gateway is displayed. The VLAN ID number is displayed. The status of the DHCP client is displayed. If you want the Ethernet switch to be a DHCP client, then select ENABLE. If you want to assign an static IP address to the Ethernet switch, then enter the IP settings and select DISABLE. IP Address Configuration (Layer 3) The IP information of the Ethernet switch is displayed here. IP Address Subnet Mask Interface Type Interface Number The IP Address of the Ethernet switch is displayed. Verify that the address you enter is correct and does not conflict with another device on the network. The subnet mask of the Ethernet switch is displayed. The type of interface. The number of the interface. Linksys One Ready Communications Solution 4 43 Chapter 4: Console Configuration Configuring the Switch through the Console or Telnet Interface