Cisco SGE2000P Administration Guide - Page 11
Uplink Ports, The Back Panel, Power Port - mgbsx1
UPC - 745883572137
View all Cisco SGE2000P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Chapter Linksys One Ready Communications Solution 2 Uplink Ports The Switch is equipped with 4 mini-GBIC uplink ports. GBIC1-4 The Switch provides four mini-GBIC ports. The mini-GBIC port is a connection point for a mini-GBIC expansion module, so the Switch can be uplinked via fiber or copper to another switch. Each mini-GBIC port provides a link to a high-speed network segment or individual workstation at speeds of up to 1000Mbps. Use the Linksys MGBT1, MGBSX1, or MGBLH1 mini-GBIC modules with the Switch. The MGBSX1 and the MGBLH1 require fiber cabling with LC connectors, while the MGBT1 requires a Category 5e Ethernet cable with an RJ-45 connector. The Back Panel The power port is located on the back panel of the Ethernet switch. 1 2 3 Power Port. The Power port is where you will 1 connect the power cord. For more details, refer to "Power Port," on page 6. Console Port. The Console port is where you can 2 connect a serial cable to a PC's serial port for configuration. For more details, refer to "Console Port," on page 7. DC INPUT FOR REMOTE POWER SUPPLY SPECIFIED IN MANUAL +12V, 7.5A 3 RPS Port. Redundant Power Supply (RPS) port. For more details, refer to "RPS Port," on page 7. Power Port The 100-240 VAC power cord is connected to the Power port. CAUTION: Only use the power cord that is supplied with the Ethernet switch. The unit may be damaged if the incorrect power cord is used. Chapter 2: Getting to Know the Switch 6 The Back Panel