Cisco WS-C3560E48PDSF-RF Hardware Installation Guide - Page 106
C-6, Stripping the DC-Input Power Source Wire, Inserting Wires in the Terminal Block Plug
UPC - 882658132667
View all Cisco WS-C3560E48PDSF-RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Connecting to DC Power Figure C-6 Stripping the DC-Input Power Source Wire 0.25 inch (6.3 mm) ± 0.02 inch (0.5 mm) Appendix C Connecting to DC Power 86460 Step 5 Insert the exposed wire of one of the four DC-input power source wires into the terminal block plug, as shown in Figure C-7. Make sure that you cannot see any wire lead. Only wire with insulation should extend from the terminal block. Warning An exposed wire lead from a DC-input power source can conduct harmful levels of electricity. Be sure that no exposed portion of the DC-input power source wire extends from the terminal block plug. Statement 122 Figure C-7 Inserting Wires in the Terminal Block Plug Return Negative Return Negative Feed A Feed B 60532 Step 6 Use a ratcheting torque screwdriver to torque the terminal block captive screw (above the installed wire lead) to 4.5 lbf-in. (72 ozf-in.), as shown in Figure C-8. Caution Do not overtorque the terminal-block captive screws. The recommended maximum torque is 4.5 lbf-in. (72 ozf-in.) Catalyst 3560 Switch Hardware Installation Guide C-6 OL-6337-07