Clifford Matrix RS III Owners Guide - Page 33

valet take-over

Get Clifford Matrix RS III PDF manuals and user guides View all Clifford Matrix RS III manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

➤ Remote control buttons and are pressed again to start the vehicle. The remote control will generate a Page Notification with a unique two-tone beep (or vibrate) and the start icon (20) will turn off when the remote start shuts down. ➜ valet take-over The Valet® Take-Over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate controls on. To perform Valet® Take-Over: 1. Before turning off the engine, simultaneously press and release and on the remote control. A remote start Page Notification with a unique two-tone beep (or vibration) will be generated and the LCD will display the start icon (20) as long as the vehicle is running. Then wait three seconds. 2. Turn the ignition key to the OFF position. (The engine will stay running.) 3. The engine will run until the pre-programmed time elapses or a shut-down input is received. (See the previous Remote Start section for a complete list of shut-down inputs.) note: This feature will not work if the brake pedal is being pressed or if any shut down input is active. 30 © 2002 directed electronics, inc.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
30
© 2002 directed electronics, inc.
➤
Remote control buttons
and
are pressed again to
start the vehicle.
The remote control will generate a Page Notification with a
unique two-tone beep (or vibrate) and the start icon (20) will
turn off when the remote start shuts down.
valet take-over
The Valet
®
Take-Over feature allows the vehicle to remain
running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the
vehicle for short periods of time, but would like to leave the
motor running and the climate controls on.
To perform Valet
®
Take-Over:
1. Before turning off the engine, simultaneously press and
release
and
on the remote control. A remote start
Page Notification with a unique two-tone beep (or vibra-
tion) will be generated and the LCD will display the start
icon (20) as long as the vehicle is running. Then wait three
seconds.
2.
Turn the ignition key to the OFF position. (The engine will
stay running.)
3.
The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous
Remote
Start
section for a complete list of shut-down inputs.)
note:
This feature will not work if the brake pedal is
being pressed or if any shut down input is active.
➜