Compaq AP200 Reference Guide - Page 67
Removing the Workstation Access Panel
UPC - 743172868534
View all Compaq AP200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
4-3 If configuration settings are incorrect, one or more devices may not work properly, and you may receive an error message. If this occurs, run the Computer Setup utility again. See Chapter 2 of this guide for more information on Computer Setup. Removing the Workstation Access Panel 1. Turn off the workstation and any external devices. 2. Disconnect the power cord from the grounded AC outlet, the network cable from the system, and disconnect any external devices. CAUTION: Before removing the workstation access panel, ensure that the workstation is turned off and that the power cord is disconnected from the grounded AC outlet. 3. Remove the two screws that secure the access panel to the workstation chassis. 4. Slide the access panel back about 1 inch (2.5 cm), then lift it off the unit. Figure 4-1. Removing the workstation access panel To replace the access panel, reverse steps 1-4. Compaq Professional Workstation AP200 Reference Guide