Compaq ProLiant 1200 Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenanc - Page 42
Terminator Board, If a single processor is installed, must be installed Compaq ProLiant 1600 only.
View all Compaq ProLiant 1200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
2-24 Removal and Replacement Procedures Terminator Board IMPORTANT: If a single processor is installed, a terminator board must be installed (Compaq ProLiant 1600 only). To remove the terminator board from the Compaq ProLiant 1600: 1. Perform the preparation procedures. See page 2-2. 2. Remove the processor cage (see page 2-21) and open the cage door. 3. Lift up two levers on each end of the terminator board . 4. Lift the terminator board from the processor cage . 1 1 2 Figure 2-21. Removing the Terminator Board Reverse steps 1 through 4 to replace the terminator board.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
2-24
Removal and Replacement Procedures
Terminator Board
IMPORTANT:
If a single processor is installed, a terminator board
must be installed (Compaq ProLiant 1600 only).
To remove the terminator board from the Compaq ProLiant 1600:
1.
Perform the preparation procedures. See page 2-2.
2.
Remove the processor cage (see page 2-21) and open the cage door.
3.
Lift up two levers on each end of the terminator board
.
4.
Lift the terminator board from the processor cage
.
1
2
1
Figure 2-21.
Removing the Terminator Board
Reverse steps 1 through 4 to replace the terminator board.