Compaq ProLiant 6400R Compaq ProLiant 6400R Servers - Page 162

I/O Fan Fan X failure

Get Compaq ProLiant 6400R PDF manuals and user guides View all Compaq ProLiant 6400R manuals
Add to My Manuals
Save this manual to your list of manuals

Page 162 highlights

Array Accelerator Read Error 3-20 Array Accelerator Write Error 3-20 Controller detects replacement drives 3-15 Drive Failure 3-16 Drive(s) Disabled due to Array Accelerator Data Loss 3-20 External Drive Subsystem Error 3-15 not Configured 3-17 Operating in Interim Recovery Mode 3-18 Recovery Needed 3-18 Reports Valid Data 3-19 resuming Automatic Data Recovery process 3-15 SCSI Port Termination Error 3-15 Drive Monitoring features are unobtainable 3-37 Drive Monitoring is NOT enabled 3-37 Drive Not Responding 3-18 Drive time-out occurred on physical drive bay X 3-37 Drive X indicates position Y 3-37 Duplicate write memory error 3-37 Error occurred reading RIS copy from SCSI Port X 3-37 Fan controller not responding 3-11 Fan failure detected 3-10 Fatal ROM Error 3-7 Fixed Disk 0 does not support DMA Mode 3-12 Fixed Disk does not support Block Mode 3-13 Fixed Disk failed Identify command 3-13 Fixed Disk failed Set Block Mode command 3-13 FYI, Drive (bay) X is non-Compaq supplied 3-37 I/O Fan (Fan X) failure detected 3-10, 3-11 I/O Fan controller not responding 3-11 I/O ROM Error 3-7 Identify controller data did not match NVRAM 3-38 Index 7 Identify logical drive data did not match NVRAM 3-38 Incorrect Drive Replaced 3-18 Insufficient adapter resources 3-38 Internal SCSI Jumper Board Not Installed 3-12 Invalid Memory Configuration 3-8 Invalid Memory Speed 3-8 Keyboard Controller Error 3-10 Keyboard Error 3-9 Keyboard or System Unit Error 3-10 Less than 75% batteries at sufficient voltage 3-38 Locked SCSI Bus Detected. 3-11 Log Reinitialized 3-8 Logical drive X failed due to cache error 3-38 Logical drive X status Failed 3-39 Interim Recovery 3-39 Loose Cable Detected 3-39 Needs Recover 3-39 Overheated 3-39 Overheating 3-39 Recovering 3-39 Wrong Drive Replaced 3-39 Loose cable detected logical drives may be marked FAILED 3-40 Loose cable detected, logical drives may be marked FAILED 3-40 Low System Battery 3-11 Memory Address Error 3-8 Memory Detection Failure 3-8 Memory Error 3-8 Memory Size Error 3-8 Mirror data miscompare 3-40 No configuration for accelerator board 3-40 Nonfunctioning Voltage Regulator Module 3-9 NVRAM configuration present, controller not detected 3-40 Parallel Port X Address Assignment Conflict 3-10 PCI slots powered down 3-11 Permanently disabled 3-34 Power Fault On Processor Bus X 3-9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
Index
7
Array Accelerator Read
Error
3-20
Array Accelerator Write
Error
3-20
Controller detects
replacement drives
3-15
Drive Failure
3-16
Drive(s) Disabled due to
Array Accelerator Data
Loss
3-20
External Drive Subsystem
Error
3-15
not Configured
3-17
Operating in Interim
Recovery Mode
3-18
Recovery Needed
3-18
Reports Valid Data
3-19
resuming Automatic Data
Recovery process
3-15
SCSI Port Termination
Error
3-15
Drive Monitoring features are
unobtainable
3-37
Drive Monitoring is NOT
enabled
3-37
Drive Not Responding
3-18
Drive time-out occurred on
physical drive bay X
3-37
Drive X indicates
position Y
3-37
Duplicate write memory
error
3-37
Error occurred reading RIS copy
from SCSI Port X
3-37
Fan controller not
responding
3-11
Fan failure detected
3-10
Fatal ROM Error
3-7
Fixed Disk 0 does not support
DMA Mode
3-12
Fixed Disk does not support
Block Mode
3-13
Fixed Disk failed Identify
command
3-13
Fixed Disk failed Set Block
Mode command
3-13
FYI, Drive (bay) X is
non-Compaq supplied
3-37
I/O Fan (Fan X) failure
detected
3-10, 3-11
I/O Fan controller not
responding
3-11
I/O ROM Error
3-7
Identify controller data did not
match NVRAM
3-38
Identify logical drive data did not
match NVRAM
3-38
Incorrect Drive Replaced
3-18
Insufficient adapter
resources
3-38
Internal SCSI Jumper Board Not
Installed
3-12
Invalid Memory
Configuration
3-8
Invalid Memory Speed
3-8
Keyboard Controller Error
3-10
Keyboard Error
3-9
Keyboard or System Unit
Error
3-10
Less than 75% batteries at
sufficient voltage
3-38
Locked SCSI Bus
Detected.
3-11
Log Reinitialized
3-8
Logical drive X failed due to
cache error
3-38
Logical drive X status
Failed
3-39
Interim Recovery
3-39
Loose Cable Detected
3-39
Needs Recover
3-39
Overheated
3-39
Overheating
3-39
Recovering
3-39
Wrong Drive
Replaced
3-39
Loose cable detected
logical drives may be
marked FAILED
3-40
Loose cable detected, logical
drives may be marked
FAILED
3-40
Low System Battery
3-11
Memory Address Error
3-8
Memory Detection Failure
3-8
Memory Error
3-8
Memory Size Error
3-8
Mirror data miscompare
3-40
No configuration for accelerator
board
3-40
Nonfunctioning Voltage
Regulator Module
3-9
NVRAM configuration present,
controller not detected
3-40
Parallel Port X Address
Assignment Conflict
3-10
PCI slots powered down
3-11
Permanently disabled
3-34
Power Fault On Processor
Bus X
3-9