Compaq ProLiant 6400R Compaq ProLiant 6400R Servers - Page 86

Run the System Configuration

Get Compaq ProLiant 6400R PDF manuals and user guides View all Compaq ProLiant 6400R manuals
Add to My Manuals
Save this manual to your list of manuals

Page 86 highlights

Diagnostics and Troubleshooting 3-19 Table 3-2 POST Error Messages continued Error Code Audible Beeps 1790-Disk 0 None Configuration Error 1791-Disk 1 Error None 1792-Drive Array None Reports Valid Data Found in Array Accelerator. Data will automatically be written to drive array. 1793-Drive Array - None Array Accelerator Battery Depleted - Data Lost (Error message 1794 also displays.) 1794-Drive Array - None Array Accelerator Battery Charge Low. Array Accelerator is temporarily disabled. Array Accelerator will be re-enabled when battery reaches full charge. 1795-Drive Array - None Array Accelerator Configuration Error. Data does not correspond to this drive array. Array Accelerator is temporarily disabled. 1796-Drive Array - None Array Accelerator Not Responding. Array Accelerator is temporarily disabled. Probable Source of Problem Hard drive error or wrong drive type Hard drive error or wrong drive type While the system was in use, power was interrupted while data were in the array accelerator memory. Power was then restored within 8 to 10 days, and the data in the array accelerator were flushed to the drive array. Recommended Action Run the System Configuration Utility and Diagnostics and correct. Run the System Configuration Utility and Diagnostics and correct. No action necessary because no data were been lost. Perform orderly system shutdowns to avoid data remaining in the array accelerator. While the system was in use, power was interrupted while data were in the array accelerator memory. Array accelerator batteries failed. Power was not restored within 8 to 10 days. The data in the array accelerator were lost. The battery charge is below 75%. Posted writes are disabled. Perform orderly system shutdowns to avoid data remaining in the array accelerator. Replace the array accelerator board if batteries do not recharge within 36 power-on hours. While the system was in use, power was interrupted while data were in the array accelerator memory. The data stored in the array accelerator do not correspond to the drive array. Match the array accelerator to the correct drive array, or run the System Configuration Utility to clear the data in the array accelerator. Array accelerator is defective or has been removed. Check that the array accelerator is properly seated. Run the System Configuration Utility to reconfigure the Compaq IDA-2 without the array accelerator. continued

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
Diagnostics and Troubleshooting
3-19
Table 3-2
POST Error Messages
continued
Error Code
Audible Beeps
Probable Source of Problem
Recommended Action
1790-Disk 0
Configuration Error
None
Hard drive error or wrong drive
type
Run the System Configuration
Utility and Diagnostics and
correct.
1791-Disk 1 Error
None
Hard drive error or wrong drive
type
Run the System Configuration
Utility and Diagnostics and
correct.
1792-Drive Array
Reports Valid Data
Found in Array
Accelerator.
Data will
automatically be
written to drive array.
None
While the system was in use,
power was interrupted while data
were in the array accelerator
memory. Power was then
restored within 8 to 10 days, and
the data in the array accelerator
were flushed to the drive array.
No action necessary because no
data were been lost. Perform
orderly system shutdowns to
avoid data remaining in the
array accelerator.
1793-Drive Array -
Array Accelerator
Battery Depleted -
Data Lost
(Error message 1794
also displays.)
None
While the system was in use,
power was interrupted while data
were in the array accelerator
memory. Array accelerator
batteries failed. Power was not
restored within 8 to 10 days. The
data in the array accelerator
were lost.
Perform orderly system
shutdowns to avoid data
remaining in the array
accelerator.
1794-Drive Array -
Array Accelerator
Battery Charge Low.
Array Accelerator is
temporarily disabled.
Array Accelerator will
be re-enabled when
battery reaches full
charge.
None
The battery charge is below
75%. Posted writes are disabled.
Replace the array accelerator
board if batteries do not
recharge within 36 power-on
hours.
1795-Drive Array -
Array Accelerator
Configuration Error.
Data does not
correspond to this
drive array. Array
Accelerator is
temporarily disabled.
None
While the system was in use,
power was interrupted while data
were in the array accelerator
memory.
The data stored in the array
accelerator do not correspond to
the drive array.
Match the array accelerator to
the correct drive array, or run
the System Configuration Utility
to clear the data in the array
accelerator.
1796-Drive Array -
Array Accelerator Not
Responding.
Array Accelerator is
temporarily disabled.
None
Array accelerator is defective or
has been removed.
Check that the array accelerator
is properly seated.
Run the System Configuration
Utility to reconfigure the
Compaq IDA-2 without the array
accelerator.
continued