Compaq ProLiant 6400R Compaq ProLiant 6400R Servers - Page 75
Table 3-2, POST Error Messages
View all Compaq ProLiant 6400R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
3-8 Compaq ProLiant 6400R Maintenance and Service Guide Table 3-2 POST Error Messages continued Error Code Audible Beeps 164-Memory Size Error 2 short 172-Configuration None Nonvolatile Memory Invalid 173-Slot ID None Mismatch 174-Configuration/ None Slot Mismatch Device Not Found 175-Configuration/ None Slot Mismatch Device Found 177-Configuration None Not Complete 178-Processor None Configuration Invalid 180-Log Reinitialized None 201-Memory Error None 203-Memory Address Error 207-Invalid Memory Configuration Check DIMM [SIMM] Installation 208-Invalid Memory Speed - Check DIMM [SIMM] Installation None None 1 long, 1 short 209-Memory Detection Failure. Check Memory Installation 211-Cache Switch Set Incorrectly 1 long, 1 short None Probable Source of Problem Incorrect configuration memory. Corrupt nonvolatile configuration or jumper installed Recommended Action Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. Board replaced, configuration not updated. EISA or PCI board not found Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. EISA or PCI board added, configuration not updated. Run the System Configuration Utility and correct. Incomplete system configuration Processor type or step does not match configuration memory. Run the System Configuration Utility and correct. Run the System Configuration Utility and correct. RAM failure RAM failure Memory module installed incorrectly. Run Diagnostics. Replace the failed assembly as indicated. Run Diagnostics. Replace the failed assembly as indicated. Verify the placement of memory modules. The speed of the memory is too slow: xx00 = expansion board SIMMs are too slow. 00yy = system board SIMMs are too slow. xx and yy have a corresponding bit set. Unable to size memory The speed of the memory modules must be 60 ns. Verify the speed of the memory modules installed, and replace them if slower than 60 ns. Check DIMM installation. If error persists, call Compaq service provider. Switch not set properly during installation or upgrade. Verify switch settings. continued