D-Link DCS-4603 User Manual - Page 16

Using the DCS-37-3 Mount (optional

Get D-Link DCS-4603 PDF manuals and user guides View all D-Link DCS-4603 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Section 2: Installation Using the DCS-37-3 Mount (optional) To mount the camera with the DCS-37-3 mount, follow the instructions below. Step 1 Place the DCS-37-3 mounting sticker in the desired location, then use a 6 mm drill bit to drill the required holes 25 mm deep and insert the wall anchors into the holes. If you plan to pass cables through the wall, you will also need to drill a hole for the cable channel. Step 2 Use the provided screws to mount the DCS-37-3 to the wall using the inner mounting holes. Step 3 Remove the cover from the camera. Pass the camera connectors through the cable channel on the DCS-37-3. Use the provided screws to mount the camera to the DCS-37-3 using the set of mounting holes marked A. Step 4 Remove the inner cover and adjust the angle and rotation of the camera as desired, then put the inner cover back in place. Step 5 Attach the camera cover. D-Link DCS-4603 User Manual 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
16
D-Link DCS-4603 User Manual
Section 2: Installation
Using the DCS-37-3 Mount (optional)
To mount the camera with the DCS-37-3 mount, follow the instructions below.
Step 2
Use the provided screws to mount the DCS-37-3 to the wall using the inner
mounting holes.
Step 1
Place the DCS-37-3 mounting sticker in the desired location, then use a 6 mm
drill bit to drill the required holes 25 mm deep and insert the wall anchors into
the holes. If you plan to pass cables through the wall, you will also need to drill
a hole for the cable channel.
Step 3
Remove the cover from the camera.
Pass the camera connectors through the cable channel on the DCS-37-3. Use the
provided screws to mount the camera to the DCS-37-3 using the set of mounting
holes marked
A
.
Step 4
Remove the inner cover and adjust the angle and rotation of the camera as
desired, then put the inner cover back in place.
Step 5
Attach the camera cover.