D-Link DGL-4100 Product Manual - Page 27
Routing, Add/Edit Route, Route List - d link ip
![]() |
UPC - 790069272547
View all D-Link DGL-4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Routing Add/Edit Route Adds a new route to the IP routing table or edits an existing route. Enable: Specifies whether the entry will be enabled or disabled. Destination IP: The IP address or network that the packets will be attempting to access Note: 192.168.1.0 with a Netmask of 255.255.255.0 means traffic will be routed to the entire 192.168.1.x network. Netmask: Used to specify which portion of the Destination IP signifies the network trying to be accessed and which part signifies the host that the packets will be routed to Note: 255.255.255.255 is used to signify only the host that was entered in the Destination IP field. Gateway: Specifies the next hop to be taken if this route is used. A gateway of 0.0.0.0 implies there is no next hop, and the IP address matched is directly connected to the router on the interface specified: LAN or WAN. Interface: Metric: Specifies the interface, LAN or WAN, that the IP packet must use to transit out of the router when this route is used. The amount of hops it will take to reach the Destination IP or network. A hop is considered to be traffic passing through a router from one network to another. If there is only one router between your network and the Destination network, then the Metric value would be 1. Save: Route List Saves the new rule or modified existing rule to the Rules list. When you are done editing the settings, you must click the Save Settings button at the top of the page to make the changes effective and permanent. This section shows the current routing table entries. Certain required routes are predefined and cannot be changed. Entries on this list that can modified can be enabled/disabled by toggling the Enable checkbox. Editable entries can be modified by clicking on the paper and pencil icon. To delete an editable entry, click on the trash can icon. After you've completed all modifications or deletions, you must click the Save Settings button at the top of the page to save your changes. The router must reboot before new settings will take effect. You will be prompted to Reboot the Device or Continue. If you need to make additional settings changes, click Continue. If you are finished with your configuration settings, click the Reboot the Device button. 27 Using the Configuration Interface Advanced > Routing D-Link Systems, Inc.
![](/manual_guide/products/dlink-dgl4100-product-manual-eac591c/27.png)