D-Link DGS-3620-28SC-EI Hardware Installation Guide - Page 44

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Hardware Installation Guide 64 Byte System Packet Forwarding Rate Priority Queues MAC Address Table DGS-3620-28PC:128Gbps DGS-3620-52T:176Gbps DGS-3620-52P:176Gbps DGS-3620-28TC/28TC-DC:95.24Mpps DGS-3620-28SC/28SC-DC:95.24Mpps DGS-3620-28PC:95.24Mpps DGS-3620-52T:130.95Mpps DGS-3620-52P:130.95Mpps 8 Priority Queues per port Supports 32K MAC address Supports 256 static MAC Port Functions Feature Console Port 1G Port PoE Specifications Detailed Description RJ-45 interface for out-of-band CLI configuration 10/100/1000Base-T ports compliant to following standards: - IEEE 802.3 compliance - IEEE 802.3u compliance - Support Full-Duplex operations - IEEE 802.3x Flow Control support for Full-Duplex mode - IEEE 802.3ab compliance - IEEE 802.3af compliance (DGS-3620-28PC & DGS-3620-52P only) - IEEE 802.3at compliance (DGS-3620-28PC & DGS-3620-52P only) SFP ports compliant to following standards: - IEEE 802.3z compliance - IEEE 802.3u compliance (Firmware R2 support) SFP Transceivers Supported: - DEM-310GT (1000Base-LX, Single-mode, 10km) - DEM-311GT (1000ase-SX, Mutli-mode, 550m) - DEM-312GT2 (1000Base-SX, Multi-mode, 2km) - DEM-314GT (1000BASE-LHX, Single-mode, 50km) - DEM-315GT (1000BASE-ZX, Single-mode, 80km) - DGS-712 (1000BASE-TX) - DEM-330T/R (1000BASE-BX, WDM transceiver, Single-Mode 10km) - DEM-331T/R (1000BASE-BX, WDM transceiver, Single-Mode 40km) - DEM-210 (100Base-FX, Multi-mode, 2km,) - DEM-211 (100Base-FX, Single-mode, 15km, - DEM-220T (100Base-BX, Wavelength Tx:1550nm, Rx:1310nm, Single-mode, 20km) - DEM-220R (100Base-BX, Wavelength Tx:1310nm, Rx:1550nm, Single-mode, 20km) 1. Supports IEEE 802.3af POE and IEEE 802.3at POE+ compliance 2. Supplies power to PD device up to 15.4W per port (802.3af) or 30W+ per port (802.3at) and more sufficiently is able to provide power to PD devices 3. Power Consumption: 370W but when connected to the RPS the consumption is 740W 4. The auto discovery feature, automatically recognizes the connection of the PD device and immediately provides power 5. Auto disable port if the port current is over 600mA while other ports remain active 6. Active circuit protection, automatically disables the port if there is a short while other ports remain active 7. For 802.3af/at capable devices, provides the power for the following classifications below: Class 0 Usage Default Max Power used by PD 12.95W 44