D-Link DGS-3620-28TC-SI Product Manual - Page 49

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide port will go into sleep mode when a port is not connected. Length Detection State Enable or disable the length detection power saving mode on the physical ports. The switch port will reduce the power feed for shorter cables. Password Encryption State Password encryption will encrypt the password configuration in configuration files. Password encryption is Disabled by default. To enable password encryption, click the Enabled radio button. Running Configuration Under the Password Recovery option, the running configuration can be enabled or disable. Being enabled, will allow the user to perform a password recovery of the running configuration. Click the Apply button to accept the changes made. To learn more about the D-Link Green Technologies, go to http://green.dlink.com/ for more details. Out of Band Management Settings This window is used to configure the out of band management port settings. To view the following window, click Management > Out of Band Management Settings, as show below: Figure 3-17 Out of Band management Settings window The fields that can be configured are described below: Parameter Description IP Address Enter the IP address of the interface. Subnet Mask Enter the subnet mask of the IP address. Gateway Enter the gateway IP address of the out-of-band management network. Satus Use the drop-down menu to enable or disable the interface status. Click the Apply button to accept the changes made. Session Table Users can display the management sessions since the Switch was last rebooted. To view the following window, click Management > Session Table, as show below: Figure 3-18 Session Table window Click the Refresh button to refresh the display table so that new entries will appear. 39