Home » D-Link Manuals » Wireless » D-Link DGS-3630 » Manual Viewer

D-Link DGS-3630 User Manual - Page 180

Group Table, L2 Interface Group Entry Type

Add to My Manuals
Save this manual to your list of manuals

Page 180 highlights

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide Restrictions: This Policy ACL Flow Table is organized into two mutually exclusive logical sub-tables. One is used to match IPv6 flows and the other one is used to match non-IPv6 flows. These two tables should be considered as a single table. But there are some restrictions: • IPv6 packets might match two rules in the Policy ACL Flow table. It is recommended add ETH_TYPE or other Match Fields in the non-IPv6 logical table to avoid this issue. • The same meter cannot be applied to two rules in different sub-tables. It is recommended to apply different meters for different rules to avoid this issue. Group Table L2 Interface Group Entry Type Field Group Identifier Group Type Counters Action Buckets Description A 32-bit unsigned integer, uniquely identifying the group on the OpenFlow switch. The naming rule is shown in the L2 Interface Group Entry Naming Conversion table. Indirect. Specifies per-group entry counters. Supports a single action bucket. L2 Interface Group Entry Naming Conversion Field Interface ID Chain ID Bits 0 to 15 16 to 27 Kind 28 to 31 Description The interface ID. The ID that other group type entries chain to. The range is from 1 to 4094. 0 (L2 Interface). L2 Interface Group Entry Bucket Actions Field Output Description Supported on physical ports only. L2 Interface Group Entry Counters Field Reference Count (Flow Entries) Duration (Seconds) Description The number of flow entries or group entries that are currently referencing this group entry. The time, in seconds, since this group entry was installed. 173

Section	Page
Table of Contents	3
1. Introduction	8
Audience	8
Other Documentation	8
Conventions	8
Notes, Notices, and Cautions	8
2. Web-based Switch Configuration	10
Management Options	10
Areas of the User Interface	12
3. System	13
Device Information	13
System Information Settings	13
Peripheral Settings	14
Port Configuration	15
Port Settings	15
Port Status	17
Port GBIC	18
Port Auto Negotiation	18
Jumbo Frame	19
Interface Description	20
Loopback Test	20
PoE	21
PoE System	21
PoE Status	22
PoE Configuration	23
PD Alive	24
PoE Statistics	25
PoE Measurement	26
System Log	26
System Log Settings	26
System Log Discriminator Settings	28
System Log Server Settings	29
System Log	30
Time and SNTP	31
Clock Settings	31
Time Zone Settings	31
SNTP Settings	33
Time Range	34
USB Console Settings	35
4. Management	36
Command Logging	36
User Accounts Settings	36
CLI Alias Settings	38
Password Encryption	39
Password Recovery	39
Login Method	40
SNMP	41
SNMP Global Settings	42
SNMP Linkchange Trap Settings	43
SNMP View Table Settings	44
SNMP Community Table Settings	45
SNMP Group Table Settings	46
SNMP Engine ID Local Settings	47
SNMP User Table Settings	47
SNMP Host Table Settings	49
RMON	50
RMON Global Settings	50
RMON Statistics Settings	50
RMON History Settings	51
RMON Alarm Settings	52
RMON Event Settings	53
Telnet/Web	54
Session Timeout	54
File System	55
Reboot Schedule Settings	57
5. Layer 2 Features	59
FDB	59
Static FDB	59
Unicast Static FDB	59
Multicast Static FDB	59
MAC Address Table Settings	60
MAC Address Table	62
MAC Notification	63
VLAN	64
802.1Q VLAN	64
VLAN Interface	65
L2VLAN Interface Description	68
STP	69
STP Global Settings	70
STP Port Settings	72
MST Configuration Identification	74
STP Instance	75
MSTP Port Information	76
Link Aggregation	76
6. Layer 3 Features	80
ARP	80
ARP Aging Time	80
Static ARP	80
ARP Table	81
IPv6 Neighbor	82
Interface	82
IPv4 Interface	82
IPv6 Interface	84
IPv4 Static/Default Route	85
IPv4 Route Table	86
IPv6 Static/Default Route	86
IPv6 Route Table	87
7. Security	89
AAA	89
AAA Global Settings	89
Application Authentication Settings	89
Application Accounting Settings	90
Authentication Settings	91
Accounting Settings	94
RADIUS	96
RADIUS Global Settings	96
RADIUS Server Settings	97
RADIUS Group Server Settings	97
RADIUS Statistic	98
TACACS+	99
TACACS+ Server Settings	99
TACACS+ Group Server Settings	100
TACACS+ Statistic	101
SSH	102
SSH Global Settings	102
Host Key	103
SSH Server Connection	104
SSH User Settings	104
SSL	105
SSL Global Settings	106
Crypto PKI Trustpoint	106
SSL Service Policy	107
SFTP Server Settings	108
Network Protocol Port Protect Settings	109
8. OAM	110
Cable Diagnostics	110
DDM	111
DDM Settings	111
DDM Temperature Threshold Settings	112
DDM Voltage Threshold Settings	112
DDM Bias Current Threshold Settings	113
DDM TX Power Threshold Settings	114
DDM RX Power Threshold Settings	114
DDM Status Table	115
9. Monitoring	116
Utilization	116
Port Utilization	116
History Utilization	116
Statistics	118
Port	118
Interface Counters	119
Interface History Counters	120
Counters	121
Device Environment	123
External Alarm Settings	124
10. Green	126
Power Saving	126
EEE	127
11. Save and Tools	129
Save Configuration	129
Firmware Upgrade & Backup	129
Firmware Upgrade from HTTP	129
Firmware Upgrade from TFTP	130
Firmware Upgrade from FTP	130
Firmware Upgrade from RCP	131
Firmware Upgrade from SFTP	132
Firmware Backup to HTTP	132
Firmware Backup to TFTP	133
Firmware Backup to FTP	133
Firmware Backup to RCP	134
Firmware Backup to SFTP	135
Configuration Restore & Backup	135
Configuration Restore from HTTP	135
Configuration Restore from TFTP	136
Configuration Restore from FTP	137
Configuration Restore from RCP	138
Configuration Restore from SFTP	138
Configuration Backup to HTTP	139
Configuration Backup to TFTP	140
Configuration Backup to FTP	140
Configuration Backup to RCP	141
Configuration Backup to SFTP	142
Certificate & Key Restore & Backup	143
Certificate & Key Restore from HTTP	143
Certificate & Key Restore from TFTP	143
Certificate & Key Restore from FTP	144
Certificate & Key Restore from RCP	144
Certificate & Key Restore from SFTP	145
Certificate & Key Backup to HTTP	146
Certificate & Key Backup to TFTP	146
Certificate & Key Backup to FTP	147
Certificate & Key Backup to RCP	147
Certificate & Key Backup to SFTP	148
Log Backup	149
Log Backup to HTTP	149
Log Backup to TFTP	149
Log Backup to RCP	150
Log Backup to SFTP	150
Ping	151
Trace Route	153
Reset	155
Reboot System	155
Appendix A - Password Recovery Procedure	156
Appendix B - System Log Entries	157
Appendix C - Trap Entries	173
Appendix D - OpenFlow Object Details	178
Flow Table	178
Policy ACL Flow Table	178
Group Table	180
L2 Interface Group Entry Type	180
L2 Rewrite Group Entry Type	181
L2 Multicast Group Entry Type	181
L3 Unicast Group Entry Type	182
L3 ECMP Group Entry Type	183