D-Link DSR-250v2 Product Manual 2 - Page 94
IPsec Client to Site, NetBIOS broadcast
View all D-Link DSR-250v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
IP address Subnet mask Remote network IP address Subnet mask NetBIOS broadcast Rollover Apply Cancel Subnet: It allows an entire subnet to connect to the VPN. Enter the network address and subnet mask in the provided fields. Enter the IP address to connect to the VPN. Enter the subnet mask for the network address. Remote site setup Select the network access type that you want to provide over the IPSec Tunnel. Any: It specifies that the policy is for any traffic from the given remote endpoint. Single IP: It limits the policy to one host. Enter the IP address of the host that will be part of the VPN. Subnet: It allows an entire subnet to connect to the VPN. Enter the network address and subnet mask in the provided fields. Enter the IP address to connect to the VPN. Enter the subnet mask for the network address. Advanced configuration Enable it to allow NetBIOS broadcast to travel over the VPN tunnel. To enable a VPN rollover, you must have the WAN Mode set to Rollover. Click Save to save your settings. Click Cancel to revert to the previous settings. IPsec Client to Site The user can manually configure it in the Ipsec client to site and build IPSec VPN tunnels. This mode is useful when you try to establish a tunnel between two DSR-250v2 devices or when you try to establish a tunnel between DSR-250v2 and/or with any third-party gateway. The fields available in the Ipsec client to site Configuration table are as follows: Field Name Interface Local subnet Enable Description It displays the name of the VPN. It displays the interface being used for the VPN connection. It displays the local subnet being used by this VPN connection. You can enable or disable the connection.