Dell 5330 Wireless and Network Guide - Page 60

The user's manual for end users must include the following information in a prominent location "IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter." EU Compliance Regulatory compliance of the DELL5002 The DELL5002 are made for OEM integrations only. The European regulations applying to the DELL5002 is the R&TTE Directive 1999/5/EC. DELL5002 meets the following requirements of the R&TTE Directive. R&TTE Directive article Article 3.1(a) Article 3.1(b) Article 3.2 Test category Protection of health and safety EMC Effective use of the spectrum Harmonized standard EN 60950-1, EN 50385 EN 301 489-1/-17 EN 300 328 The conformity assessment for the DELL5002 were completed in accordance with the R&TTE Directive Annex IV procedures, and the EC Declaration of Conformity is attached to this manual. Cautions regarding regulatory compliance when integrating the DELL5002 The person integrating the DELL5002 becomes the manufacturer of the final product and is therefore responsible for demonstrating compliance of the product with the essential requirements of the R&TTE Directive. In all cases assessment of the final product must be made against the Essential requirements of the R&TTE Directive Article 3.1(a) and (b), safety and EMC respectively, and any relevant Article 3.3 requirements This device is intended only for OEM integrators under the following conditions: 1 This appliance and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. 58 Appendix I. Regulatory statement