Dell Brocade 5100 Brocade 7.3.0 Fabric OS Message Reference Guide - Page 418

5 FCR-1060 FCR-1060 Message Message Type Severity Probable Cause Recommended Action EX_Port() has an incompatible configuration setting. LOG WARNING Indicates that virtual channel (VC) Link Init is enabled on the local switch and the remote switch is negotiating in R_RDY mode. The fabric might not form properly. Check the configuration on the local switch using the portCfgShow command to verify that the VC Link Init is disabled, if the remote switch is configured in R_RDY mode or only capable of R_RDY mode. • VC_RDY mode: Virtual channel flow control mode. This is a proprietary protocol. • R_RDY mode: Receiver-ready flow control mode. This is the Fibre Channel standard protocol, that uses R_RDY primitive for flow control. FCR-1061 Message Message Type Severity Probable Cause Recommended Action Backbone fabric created on port . LOG INFO Indicates that a backbone fabric was built on the specified port. No action is required. FCR-1062 Message Message Type Severity Probable Cause Recommended Action Port disabled, system only supports EX/VEX_ports. LOG INFO Indicates that the maximum number of supported EX_Ports or VEX_Ports was exceeded. To enable the specified port, disable any other operational port and then re-enable the port. No action is required. 396 Fabric OS Message Reference 53-1003140-01