Dell Chromebook 3110 Service Manual - Page 54

Replace the four screws M2x3 to secure the display panel to the display assembly.

Get Dell Chromebook 3110 PDF manuals and user guides View all Dell Chromebook 3110 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 54 highlights

Steps 1. Connect the display cable to the connector on the back of the display panel. 2. Adhere the rubber spacer on the display cable. 3. Adhere the clear tape on the display cable connector. NOTE: For Chromebook 3110 systems shipped with WWAN, route the display cable along the routing channels at the bottom-left side of the display back-cover and then adhere the piece of conductive tape to secure the display cable in place. 4. Adhere the conductive tape to secure the display cable connector. 5. Flip the display panel to align it with the screw holders on the display assembly. 6. Replace the four screws (M2x3) to secure the display panel to the display assembly. Next steps 1. Install the display bezel. 2. Install the display assembly. 3. Install the WWAN card for systems enabled with 4G LTE. 4. Install the base cover. 5. Follow the procedure in After working inside your computer. 54 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
Steps
1.
Connect the display cable to the connector on the back of the display panel.
2.
Adhere the rubber spacer on the display cable.
3.
Adhere the clear tape on the display cable connector.
NOTE:
For Chromebook 3110 systems shipped with WWAN, route the display cable along the routing channels at the
bottom-left side of the display back-cover and then adhere the piece of conductive tape to secure the display cable in
place.
4.
Adhere the conductive tape to secure the display cable connector.
5.
Flip the display panel to align it with the screw holders on the display assembly.
6.
Replace the four screws (M2x3) to secure the display panel to the display assembly.
Next steps
1.
Install the
display bezel
.
2.
Install the
display assembly
.
3.
Install the
WWAN card
for systems enabled with 4G LTE.
4.
Install the
base cover
.
5.
Follow the procedure in
After working inside your computer
.
54
Removing and installing components