Dell E2209WFP Dell™ E2009W/E2209W Flat Panel Monitor User's Guide - Page 10

Setting Up the Monitor:Dell E2009W/E2209W Flat Panel Monitor User's Guide, Attaching the Stand

Get Dell E2209WFP PDF manuals and user guides View all Dell E2209WFP manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Back to Contents Page Setting Up the Monitor Dell™ E2009W/E2209W Flat Panel Monitor User's Guide Attaching the Stand Connecting the Monitor Organizing the Cables Attaching the Soundbar (optional) Removing the Stand Wall Mounting (Optional) Attaching the Stand NOTE: The stand is detached from monitor when they are shipped from the factory. Place the stand on a flat surface and follow these steps to attach the monitor stand: 1. Fit the groove on the back of the monitor to the two tabs on the upper part of the stand. 2. Lower the monitor so that the monitor mounting area snaps on to or locks on to the stand. Connecting Your Monitor CAUTION: Before you begin any of the procedures in this section, follow the Safety Instructions. To connect your monitor to the computer: 1. Turn off your computer and disconnect the power cable. 2. Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not connect both cables on the same computer. Use both the cables only when they are connected to two different computers with appropriate video systems. Connecting the White DVI Cable

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
Back to Contents Page
Setting Up the Monitor
Dell™ E2009W/E2209W Flat Panel Monitor User's Guide
Attaching the Stand
Connecting the Monitor
Organizing the Cables
Attaching the Soundbar (optional)
Removing the Stand
Wall Mounting (Optional)
Attaching the Stand
NOTE:
The stand is detached from monitor when they are shipped from the factory.
Place the stand on a flat surface and follow these steps to attach the monitor stand:
1. Fit the groove on the back of the monitor to the two tabs on the upper part of the stand.
2. Lower the monitor so that the monitor mounting area snaps on to or locks on to the stand.
Connecting Your Monitor
CAUTION:
Before you begin any of the procedures in this section, follow the
Safety Instructions
.
To connect your monitor to the computer:
1. Turn off your computer and disconnect the power cable.
2. Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not
connect both cables on the same computer. Use both the cables only when they are connected to two different computers with appropriate video systems.
Connecting the White DVI Cable