Dell EqualLogic PS6210S PS6210 Hardware Owners Manual - Page 34
Removing the Battery Cover, Disconnecting the Battery
View all Dell EqualLogic PS6210S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
PS6210 Hardware Owner's Manual 3 Maintaining Control Modules Set the screw aside before you remove the cover; otherwise, the screw might fall inside the control module. If this occurs, you might have to return the control module to Dell for servicing. 4. Using the screw tab as a handle, swing the battery cover up and to the left and lay it upside down on the control module (Figure 25). The battery cover will be heavier than expected because the battery is attached to the cover. Figure 25: Removing the Battery Cover 5. The connector that connects to the battery unit is held in place by a retaining clip, which must be depressed to remove the connector, as shown in Figure 26. Grasp the outside of the connector, while simultaneously depressing the retaining clip, and wiggle the connector gently side to side while pulling outward to remove it. Set the old battery unit aside. Figure 26: Disconnecting the Battery 28