Dell Equallogic PS6010 Storage Arrays - Hardware Owners Manual - Page 36
Installing a Control Module, Removing a Control Module
View all Dell Equallogic PS6010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
PS6010 Hardware Maintenance Maintaining Control Modules Figure 3-3: Removing a Control Module 3. Place the control module on a flat surface where it will be protected from electrostatic charge. Caution: To avoid damage, do not place anything on top of the control module. 4. If you are replacing a failed control module, remove the microSD card from the failed control module and install it in the replacement control module. This will make sure that the new control module is running the correct firmware. See Replacing the MicroSD Card on page 3-11. Caution: Do not operate an array with an empty control module slot. Return the failed control module in the packaging in which the replacement module was shipped. Contact your PS Series support provider for information about returning hardware. Installing a Control Module You can install a control module without shutting down the array. Caution: Do not mix control module types in an array. 3-8