Dell Equallogic PS6010 Storage Arrays - Hardware Owners Manual - Page 38
Installing a Control Module, Installation and, Setup, Interpreting Control Module
View all Dell Equallogic PS6010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
PS6010 Hardware Maintenance Maintaining Control Modules Figure 3-5: Installing a Control Module 4. Rotate each latch inward, while pushing the control module completely into the slot. The latches will snap into place (Figure 3-5). 5. Connect the network cables. For detailed information, see the Installation and Setup guide. 6. If the array was shut down, turn on power to the array. 7. Make sure the control module is operationa.l See Interpreting Control Module LEDs on page 3-2. If two control modules are installed but only one appears in the GUI or CLI, the control module may not be properly installed. Reinstall the control module. If both control modules still do not appear in the GUI or CLI, they may not be running the same firmware. Contact your array support provider. Note: When connected, a control module cache battery may begin to charge. If the low-battery-safe cache policy is enabled (the default), the array will operate in write-through mode until the cache battery is fully charged. However, if you need optimal performance before the battery is fully charged, as soon as the battery status is good/charging, you can 3-10