Dell Force10 S25-01-GE-24P Installing the S25P System - Page 10
Equipment, Features, Ports, Four shared RJ45 10/100/1000 Base-T ports
View all Dell Force10 S25-01-GE-24P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Equipment The following items are necessary to install the S25P system: • The switch • At least one grounded AC power source per S25P • One AC cable is included to connect the AC power source to the S25P (power cables are not supplied for the S25P-DC) • Bracket ears for rack installation (supplied) • Screws for rack installation (supplied) and #2 Phillips screwdriver (not supplied) Other optional components are: • Stacking cables for connecting S-Series switches in a stack • Optical networking components (see Chapter 4, Installing Ports, on page 29) • Stacking components (see Ports, below) Features • S25P CPU and switch processor • 32MB internal Flash memory • 256MB RAM • Stackable switch features • 19-inch rack-mountable • Standard 1U chassis height • Six built-in fans • Two internal AC power supplies acting in load-sharing mode • Up to 16384 MAC address entries supported with hardware-assisted aging • Supports 9252-byte jumbo frames in FTOS, 9216-byte jumbo frames in SFTOS • Back-pressure support at half-duplex, IEEE 802.3x flow control at full duplex • Extensive LED system with per-port LEDs Ports • 24 SFP ports capable of using 100/1000 Base-T or 1000 Base-X using auto-media detect • Four shared RJ45 10/100/1000 Base-T ports • Console port (see Accessing the Console Port on page 29): Supplied with console cable (straight-through Ethernet copper cable) and terminal adapter (DB-9 to RJ-45) • Two expansion slots that accept any combination of the following optional, high-capacity uplink modules: - 10GbE XFP (two ports) - 10GbE CX4 (two ports) - 12G Stacking (two ports) - 24G Stacking (one port) See Inserting Optional Modules (10-Gigabit or Stacking) on page 17 and Connecting Stack Ports (optional) on page 25. 10 S25P System Overview