Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1090

www.dell.com | support.dell.com permit c e s Configure a rule for the redirect list. Syntax permit {ip-protocol-number | protocol-type} {source mask | any | host ip-address} {destination mask | any | host ip-address} [bit] [operators] To remove the rule, use one of the following: • If you know the filter sequence number, use the no seq sequence-number syntax. • no permit {ip-protocol-number | protocol-type} {source mask | any | host ip-address} {destination mask | any | host ip-address} [bit] [operators] Parameters ip-protocol-number protocol-type source mask any host ip-address destination bit operator Enter a number from 0 to 255 for the protocol identified in the IP protocol header. Enter one of the following keywords as the protocol type: • icmp for Internet Control Message Protocol • ip for Any Internet Protocol • tcp for Transmission Control Protocol • udp for User Datagram Protocol Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x). Enter the keyword any to specify that all traffic is subject to the filter. Enter the keyword host followed by the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) For TCP protocol type only, enter one or a combination of the following TCP flags: • ack = acknowledgement • fin = finish (no more data from the user) • psh = push function • rst = reset the connection • syn = synchronize sequence number • urg = urgent field (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (you must specify two ports for the port command parameter.) Defaults No default behavior or values Command Modes REDIRECT-LIST Command History Version 8.4.2.1 Version 8.4.2.0 Version 7.5.1.0 Introduced on the C-Series and S-Series Introduced on the E-Series TeraScale Introduced on the E-Series ExaScale 1090 | Policy-based Routing (PBR)