Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 626
Time Domain Reflectometer (TDR
View all Dell Force10 S25-01-GE-24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 626 highlights
www.dell.com | support.dell.com • In the event of fragmented packets, egress port of the first fragment. • In the event of fragmented packets, egress port of the subsequent fragments. Example show port-channel-flow outgoing-port-channel number incoming-interface interface source-mac address destination-mac address • Load-balance is configured for MAC • Load balance is configured for IP 4-tuple/2-tuple for the C-Series and S-Series • A non-IP payload is going out of Layer 2 LAG interface that is a member of VLAN with an IP address. Figure 24-47. show port-channel-flow Command for MAC Addresses Force10#show port-channel-flow outgoing-port-channel 1 incoming-interface gi 3/0 source-mac 00:00:50:00:00:00 destination-mac 00:00:a0:00:00:00 Egress Port for port-channel 1, for the given flow, is Te 13/01 Example On the E-Series only: show port-channel-flow outgoing-port-channel number incoming-interface interface source-ip address destination-ip address {protocol number [icmp/tcp/udp]} {source-port number destination-port number} Related Commands • Load balance is configured for IP 5-tuple/3-tuple. • An IP payload is going out of a Layer 2 LAG interface that is a member of a VLAN with an IP address. Force10#show port-channel-flow outgoing-port-channel 2 incoming-interface gi 3/0 source-ip 2.2.2.0 destination-ip 3.2.3.1 protocol tcp source-port 5 destination-port 6 Egress Port for port-channel 2, for the given flow: Unfragmented packet: Gi 1/6 Fragmented packets (first fragment): Gi 1/12 Fragmented packets (remaining fragments): Gi 1/12 load-balance (E-Series) Balance traffic over E-Series port channel members. Time Domain Reflectometer (TDR) e TDR is supported on E-Series ExaScale x with FTOS 8.2.1.0. and later. TDR is useful for troubleshooting an interface that is not establishing a link; either it is flapping or not coming up at all. TDR detects open or short conditions of copper cables on 100/1000 Base-T modules. • tdr-cable-test • show tdr 626 | Interfaces