Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1137

44 Power over Ethernet (PoE) Overview FTOS supports Power over Ethernet (PoE), as described by IEEE 802.3af, on C-Series and S-Series systems (S25V and S50V models), as indicated by the c and s characters, respectively, that appear below each command heading. Commands This chapter contains the following commands: • power budget • power inline • power inline priority • show power detail • show power inline • show power supply power budget s If an S25V or S50V model of the S-Series has an external power supply, this command allows the external power supply of the specified stack member to be used for powering PoE ports. An external DC power supply operates, by default, in backup mode. However, if the power supply is the 470W Redundant Power Supply (catalog # S50-01-PSU-V) from Dell Force10, and it is attached to the Current Sharing terminal, you can use this command to convert its use to load-sharing mode to support additional PoE devices. Other external DC power supplies are not supported for PoE. Syntax [no] power budget stack-unit 0-7 321-790 Enter no power budget stack-unit 0-7 to disable the use of power for PoE from the external power supply on the designated stack member. Parameters 0-7 321-790 Enter the stack unit ID, from 0 to 7, of the stack member that you want to configure. After entering the stack unit number, enter a value representing the watts to be used for PoE. Range: 321 to 790 Defaults 320W (i.e., redundancy mode) Power over Ethernet (PoE) | 1137