Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 152

www.dell.com | support.dell.com Command History Version 8.2.1.0 Version 8.1.1.0 Version 7.9.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on E-Series ExaScale (IPv6) Increased number of VLANs on ExaScale to 4094 (was 2094) Introduced on E-Series ExaScale (IPv4) Introduced VRF. Introduced on S-Series Introduced on C-Series and added support for IPv6 address on E-Series only Usage Telnet to link-local addresses is not supported. Information telnet-peer-rpm c e Open a Telnet connection to the peer RPM. Syntax telnet-peer-rpm Defaults Not configured. Command Modes EXEC EXEC Privilege Command History Version 8.1.1.0 Version 7.5.1.0 Version 6.2.1.1 Introduced on E-Series ExaScale Introduced on C-Series Introduced on E-Series Usage Information Opening a telnet connection from the Standby RPM to an Active RPM follows the authentication procedure configured in the chassis. However, opening a telnet connection from the Active RPM into the Standby RPM requires local authentication. Configuring an ACL on a VTY line will block a Telnet session using the telnet-peer-rpm command in the standby to active RPM direction only. Such an ACL will not block an internal Telnet session in the active RPM to standby RPM direction. 152 | Control and Monitoring