Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 32

www.dell.com | support.dell.com Parameters directory (OPTONAL) Enter one of the following: • flash: (internal Flash) or any sub-directory • slot0: (external Flash) or any sub-directory (C-Series and E-Series only) Command Modes EXEC Privilege Command History Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command change bootflash-image c e Change boot flash image from which to boot. Syntax change bootflash-image {cp | linecard linecard-slot | rp} Parameters cp linecard linecard-slot rp Enter the keyword cp to change the bootflash image on the Control Processor on the RPM. Enter the keyword linecard followed by the slot number to change the bootflash image on a specific line card. C-Series Range: 0-7 E-Series Range: 0 to 13 on the E1200; 0 on 6 on the E600, and 0 to 5 on the E300. Enter the keyword rp to change the bootflash image on the RPM Route Processor. Defaults Not configured. Command Modes EXEC Privilege Command History Version 7.5.1.0 Introduced on C-Series E-Series original Command Usage A system message appears stating that the bootflash image has been changed. You must reload the Information system before the system can switch to the new bootflash image. copy c e s Syntax Copy one file to another location. FTOS supports IPv4 and IPv6 addressing for FTP, TFTP, and SCP (in the hostip field). copy source-file-url destination-file-url 32 | File Management