Dell Force10 S25-01-GE-24V FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 602

www.dell.com | support.dell.com show interfaces phy c e s Display auto-negotiation and link partner information. Syntax show interfaces gigabitethernet slot/port phy Parameters gigabitethernet Enter the keyword gigabitethernet followed by the slot/port information. Command Modes EXEC EXEC Privilege Command History Version 8.1.1.0 Version 7.6.1.0 Version 6.5.4.0 Introduced on E-Series ExaScale Introduced on C-Series and S-Series Introduced on E-Series Example Figure 24-36. show interfaces gigabitethernet phy Command Example (Partial) Force10#show int gigabitethernet 1/0 phy Mode Control: SpeedSelection: 10b AutoNeg: ON Loopback: False PowerDown: False Isolate: False DuplexMode: Full Mode Status: AutoNegComplete: False RemoteFault: False LinkStatus: False JabberDetect: False AutoNegotation Advertise: 100MegFullDplx: True 100MegHalfDplx: True 10MegFullDplx: False 10MegHalfDplx: True Asym Pause: False Sym Pause: False AutoNegotiation Remote Partner's Ability: 100MegFullDplx: False 100MegHalfDplx: False 10MegFullDplx: False 10MegHalfDplx: False Asym Pause: False Sym Pause: False AutoNegotiation Expansion: ParallelDetectionFault: False ... Table 24-8. Lines in show interfaces gigabitethernet Command Example Line Mode Control Mode Status AutoNegotiation Advertise Description Indicates if auto negotiation is enabled. If so, indicates the selected speed and duplex. Displays auto negotiation fault information. When the interface completes auto negotiation successfully, the autoNegComplete field and the linkstatus field read "True." Displays the control words advertised by the local interface during negotiation. Duplex is either half or full. Asym- and Sym Pause is the types of flow control supported by the local interface. 602 | Interfaces