Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 314

www.dell.com | support.dell.com Usage Information The MED is a 4-Byte unsigned integer value and the default behavior is to assume a missing MED as 4294967295. This command causes a missing MED to be treated as 0. During the path selection, paths with a lower MED are preferred over those with a higher MED. Command History Version 7.8.1.0 Version 7.7.1.0 Version 6.3.1.0 Introduced support on S-Series Introduced support on C-Series Introduced bgp bestpath router-id ignore c e s Do not compare router-id information for external paths during best path selection. Syntax bgp bestpath router-id ignore To return to the default selection, use the no bgp bestpath router-id ignore command. Defaults Disabled Command Modes ROUTER BGP Usage Configuring this option will retain the current best-path. When the session is subsequently reset, the Information oldest received path will be chosen as the best-path. Command History Version 8.3.1.0 Introduced bgp client-to-client reflection c e s Enables you to enable route reflection between clients in a cluster. Syntax bgp client-to-client reflection To disable client-to-client reflection, enter no bgp client-to-client reflection. Defaults Enabled when a route reflector is configured. Command Modes ROUTER BGP Usage Route reflection to clients is not necessary if all client routers are fully meshed. Information Related Commands bgp cluster-id neighbor route-reflector-client Assign ID to a BGP cluster with two or more route reflectors. Configure a route reflector and clients. Command History Version 7.8.1.0 Version 7.7.1.0 Introduced support on S-Series Introduced support on C-Series 314 | Border Gateway Protocol IPv4 (BGPv4)