Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 79

configure c e s Enter the CONFIGURATION mode from the EXEC Privilege mode. Syntax configure [terminal] Parameters terminal (OPTIONAL) Enter the keyword terminal to specify that you are configuring from the terminal. Command Modes EXEC Privilege Command History Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command Example Figure 5-2. Command Example: configure Force10#configure Force10(conf)# debug cpu-traffic-stats c e s Enable the collection of CPU traffic statistics. Syntax debug cpu-traffic-stats Defaults Disabled Command Modes EXEC Privilege Command History Version 7.6.1.0 Version 7.5.1.0 Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information This command enables (and disables) the collection of CPU traffic statistics from the time this command is executed (not from system boot). However, excessive traffic received by a CPU will automatically trigger (turn on) the collection of CPU traffic statics. The following message is an indication that collection of CPU traffic is automatically turned on. Use the show cpu-traffic-stats to view the traffic statistics. Excessive traffic is received by CPU and traffic will be rate controlled. Note: This command must be enabled before the show cpu-traffic-stats command will display traffic statistics. Dell Force10 recommends that you disable debugging (no debug cpu-traffic-stats) once troubleshooting is complete. Related Commands show cpu-traffic-stats Display cpu traffic statistics Control and Monitoring | 79