Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 591
show interfaces Command Example for 10G Port EtherScale
View all Dell Force10 S50-01-GE-48T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 591 highlights
Version 6.4.1.0 Version 6.3.1.0 Changed organization of display output Added Pluggable Media Type field in E-Series TeraScale output Usage Use this show interfaces command for details on a specific interface. Use the show interfaces linecard command for details on all interfaces on the designated line card. Note that, in an E-Series EtherScale chassis, the show interfaces command output does not include details about installed SFP or XFP transceivers. Example Figure 24-27. show interfaces Command Example for 10G Port (EtherScale in E-Series) Force10#show interfaces tengigabitethernet 2/0 TenGigabitEthernet 2/0 is up, line protocol is up Hardware is Force10Eth, address is 00:01:e8:05:f7:3a Interface index is 100990998 Internet address is 213.121.22.45/28 MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 10000 Mbit ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interfaces" counters 02:31:45 Queueing strategy: fifo Input Statistics: 0 packets, 0 bytes Input 0 IP Packets, 0 Vlans 0 MPLS 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 symbol errors, 0 runts, 0 giants, 0 throttles 0 CRC, 0 IP Checksum, 0 overrun, 0 discarded Output Statistics: 1 packets, 64 bytes, 0 underruns 0 Multicasts, 2 Broadcasts, 0 Unicasts 0 IP Packets, 0 Vlans, 0 MPLS 0 throttles, 0 discarded Rate info (interval 299 seconds): Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Time since last interface status change: 00:00:27 Table 24-5. Lines in show interfaces Command Example (EtherScale) Line TenGigabitEthernet 2/0... Hardware is... Interface index... Internet address... MTU 1554... LineSpeed ARP type:... Last clearing... Queuing strategy... Description Displays the interface's type, slot/port, and administrative and line protocol status. Displays the interface's hardware information and its assigned MAC address. Displays the interface index number used by SNMP to identify the interface. States whether an IP address is assigned to the interface. If one is, that address is displayed. Displays link and IP MTU information. If the chassis is in Jumbo mode, this number can range from 576 to 9252. Displays the interface's line speed. Displays the ARP type and the ARP timeout value for the interface. Displays the time when the show interfaces counters where cleared. States the packet queuing strategy. FIFO means first in first out. Interfaces | 591