Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 331

Command Modes EXEC Privilege Usage This command turns on BGP soft-reconfiguration inbound debugging for IPv4 unicast routes. If no Information neighbor is specified, debug is turned on for all neighbors. Command History Version 8.4.1.0 Version 7.8.1.0 Version 7.7.1.0 Version 7.2.1.0 Introduced support for IPv4 multicast and IPv6 unicast routes Introduced support on S-Series Introduced support on C-Series Introduced debug ip bgp updates c e s Enables you to view information about BGP updates. Syntax debug ip bgp updates [in | out | prefix-list prefix-list-name] To disable debugging, use the no debug ip bgp [ip-address | peer-group peer-group-name] updates [in | out] command. Parameters in out prefix-list prefix-list-name ip-address peer-group-name (OPTIONAL) Enter the keyword in to view only BGP updates received from neighbors. (OPTIONAL) Enter the keyword out to view only BGP updates sent to neighbors. (OPTIONAL) Enter the keyword prefix-list followed by the name of an established prefix list. If the prefix list is not configured, the default is permit (to allow all routes). (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format. (OPTIONAL) Enter the name of the peer group to disable or enable all routers within the peer group. Command Modes EXEC Privilege Usage Enter no debug ip bgp command to remove all configured debug commands for BGP. Information Command History Version 7.7.1 Introduced support on C-Series default-metric c e s Enables you to change the metrics of redistributed routes to locally originated routes. Use this command with the redistribute command. Syntax default-metric number To return to the default setting, enter no default-metric. Parameters number Enter a number as the metric to be assigned to routes from other protocols. Range: 1 to 4294967295. Border Gateway Protocol IPv4 (BGPv4) | 331