Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 615
switchport
View all Dell Force10 S50-01-GE-48T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 615 highlights
Command Modes INTERFACE Command History Version 8.1.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Introduced on E-Series ExaScale Introduced on C-Series Introduced for E-Series Usage This command is found on the Management interface only. Information Related Commands interface ManagementEthernet duplex (Management) management route Configure the Management port on the system (either the Primary or Standby RPM). Set the mode of the Management interface. Configure a static route that points to the Management interface or a forwarding router. switchport c e s Place an interface in Layer 2 mode. Syntax Parameters switchport [backup interface {gigabit slot/port | tengigabit slot/port | port-channel number}] To remove an interface from Layer 2 mode and place it in Layer 3 mode, enter no switchport. If a switchport backup interface is configured, you must first remove the backup configuration. To remove a switchport backup interface, enter no switchport backup interface {gigabit slot/port | tengigabit slot/port | port-channel number}]. backup interface gigabit tengigabit port-channel slot/port Use this option to configure a redundant Layer 2 link without using Spanning Tree. This keyword configures a backup port so that if the primary port fails the backup port changes to the up state. If the primary later comes up, it becomes the backup. Enter this keyword if the backup port is a 1G port. Enter this keyword if the backup port is a 10G port. Enter this keyword if the backup port is a static or dynamic port channel. Specify the line card and port number of the backup port. Defaults Disabled (The interface is in Layer 3 mode.) Command Modes INTERFACE Command History Version 8.4.1.0 Version 8.1.1.0 Version 7.7.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Added support for port-channel interfaces (port-channel number option). Introduced on E-Series ExaScale Added backup interface option. Introduced on S-Series Introduced on C-Series Introduced for E-Series Interfaces | 615