Dell Force10 Z9000 Dell Force10 Z9000 System Quick Start Guide - Page 20
Create a Port-based VLAN, Assign Interfaces to a VLAN
View all Dell Force10 Z9000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Create a Port-based VLAN The Default VLAN as VLAN 1 is part of the system startup configuration and does not require configuration. To configure a port-based VLAN, you must create the VLAN and then add physical interfaces or port channel (LAG) interfaces to the VLAN. Task Configure a port-based VLAN. Command Syntax Command Mode interface vlan vlan-id CONFIGURATION NOTE: After you create a VLAN, you must assign interfaces in Layer 2 mode to the VLAN to activate the VLAN. Use the show vlan command in the EXEC privilege mode to view the configured VLANs. Assign Interfaces to a VLAN To view just the interfaces that are in Layer 2 mode, enter the show interfaces switchport command in the EXEC privilege mode or EXEC mode. To tag frames leaving an interface in Layer 2 mode, you must assign that interface to a port-based VLAN to tag it with that VLAN ID. To tag interfaces, use these commands in the following sequence: Step Task Command Syntax 1 Access the interface vlan vlan-id INTERFACE VLAN mode of the VLAN to which you want to assign the interface. 2 Enable an interface to tagged interface include the IEEE 802.1Q tag header. Command Mode CONFIGURATION INTERFACE Use the untagged command to move untagged interfaces from the Default VLAN to another VLAN: 18 Installing the Software