Dell I15RN-3647BK Service Manual - Page 45
Remove the jumper plug from pins 2 and 3.
View all Dell I15RN-3647BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
2. Reset the current CMOS settings: a. Locate the 3-pin CMOS jumper (CLR CMOS) on the system board. b. Remove the jumper plug from pins 2 and 3. c. Place the jumper plug on pins 1 and 2 and wait approximately 5 seconds. d. Replace the jumper plug on pins 2 and 3. 3. Close the computer cover. NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer. 4. Connect your computer and devices to electrical outlets, and turn them on. Back to Contents Page
2.
Reset the current CMOS settings:
a.
Locate the 3-pin CMOS jumper (CLR CMOS) on the
system board
.
b.
Remove the jumper plug from pins 2 and 3.
c.
Place the jumper plug on pins 1 and 2 and wait approximately 5 seconds.
d.
Replace the jumper plug on pins 2 and 3.
3.
Close the computer cover
.
4.
Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.