Dell Inspiron 11z 1110 Inspiron 11z 1110 Service Manual - Page 31

Back to Contents Page LED Board Dell™ Inspiron™ 11 Service Manual Removing the LED Board Replacing the LED Board WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty. CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer). CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the computer. Removing the LED Board 1. Follow the procedures in Before You Begin. 2. Remove the battery (see Removing the Battery). 3. Remove the keyboard (see Removing the Keyboard). 4. Remove the palm rest (see Removing the Palm Rest). 5. Disconnect the speaker cable from the speaker cable connector on the I/O board (see Removing the Speakers). 6. Remove the hard drive (see Removing the Hard Drive). 7. Remove the memory module (see Removing the Memory Module). 8. Remove the palm rest bracket (see Removing the Palm Rest Bracket). 9. Disconnect the LED board cable from the system board connector. 10. Remove the screw that secures the LED board to the computer base. 11. Lift the LED board off the computer base. 1 screw 2 3 system board connector LED board Replacing the LED Board 1. Follow the procedures in Before You Begin. 2. Place the LED board on the computer base.