Dell Inspiron 13 5310 Service Manual - Page 28

Adhere the tape that secures the speaker cable to the palm-rest and keyboard assembly.

Get Dell Inspiron 13 5310 PDF manuals and user guides View all Dell Inspiron 13 5310 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Steps 1. Using the alignment posts, place the left speaker on the palm-rest and keyboard assembly. NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker. 2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly. 3. Using the alignment posts, place the right speaker on the palm-rest and keyboard assembly. NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker. 4. Connect the speaker cable to the connector on the system board. 5. Adhere the tape that secures the speaker cable to the palm-rest and keyboard assembly. 6. Place the Mylar over the system board. Next steps 1. Install the battery. 2. Install the base cover. 3. Follow the procedure in After working inside your computer. 28 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
Steps
1.
Using the alignment posts, place the left speaker on the palm-rest and keyboard assembly.
NOTE:
Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
2.
Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3.
Using the alignment posts, place the right speaker on the palm-rest and keyboard assembly.
NOTE:
Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
4.
Connect the speaker cable to the connector on the system board.
5.
Adhere the tape that secures the speaker cable to the palm-rest and keyboard assembly.
6.
Place the Mylar over the system board.
Next steps
1.
Install the
battery
.
2.
Install the
base cover
.
3.
Follow the procedure in
After working inside your computer
.
28
Removing and installing components