Dell Inspiron 24 5410 All-in-One Service Manual - Page 14
Installing the stand, Steps, Prerequisites, About this task
View all Dell Inspiron 24 5410 All-in-One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Steps 1. Locate the tab on the stand, and push a scribe into the tab to release the stand from the display-assembly base. 2. Lift the stand off the display-assembly base. Installing the stand Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. NOTE: The following procedure is applicable for both Y stand and Isosceles stand. NOTE: For replacement of stand or display hinges, the replacement kit is shipped with both stand and display hinges, and you must replace both of these components together. Refer to the procedure for removing the display hinges and installing the display hinges. About this task The following image indicates the location of the stand and provides a visual representation of the installation procedure. 14 Removing and installing components